About Caster：Types of Mounting Methods

1. Plate Type

Holes for mounting a caster are provided on the mounting base. Mount the caster using screws and bolts as illustrated in the figure.
※ Please make sure to use all mounting holes.

2. Screw-in Type

Since a thread is provided on the stem, mount a caster by screwing the caster on the stem.
After lightly screwing a caster by hand, mount the caster by tightening the hexagonal part using a dedicated flat wrench as illustrated in the figure.
At that time, drive screws firmly to the end.
※ If screws are not screwed in to the end, allowable load may be reduced.

3. Insertion Type(Rubber Pipe Type)

Since a rubber pipe is provided on the stem, a caster can be mounted by inserting it into a pipe, etc.
After inserting the caster, tighten the hexagonal part using a flat wrench as illustrated in the figure and inflate the rubber pipe.
At that time, drive screws firmly to the end.
※ If screws are not screwed in to the end, allowable load may be reduced.

4. Angle Type

A caster can be easily mounted to the angle using screw and bolts.
Make sure to firmly insert the angle to inside of the mounting bracket to make the bracket close contact with the angle.
At last, fix the mounting holes and the holes on the angle, and then mount a caster using screw and bolts.
※ If the angle is not inserted to the end of the inside of the mounting bracket, allowable load may be reduced.